T-WRECKS

Your vessel must undergo an annual inspection within the 3 months before or after each anniversary date. Vessel missed annual inspection window. Vessel must undergo a COI Inspection prior to the carriage of passengers. 46 CFR 176.500(b)(1) 701c

Your vessel must undergo an annual inspection within the 3 months before or after each anniversary date. Vessel missed annual inspection window. Vessel must undergo a COI Inspection prior to the carriage of passengers. 46 CFR 176.500(b)(1) 701c

Vessel had expired radiotelephone certificate. Vessel is restricted to 1NM operations until valid certificate is issued. 46 CFR 184.520 47 CFR 80.903

A vsl must comply with the applicable requirements for any radio and Electronic Position Indicating Radiobeacon (EPIRB) installations, including the requirements for a station license and installation certificates to be issued by the Federal Communications Commission. Vessel certificated Oceans Route and was operating over 20 nm from shore with no installed and certificated MF radio onboard. Install and have MF radio certificated by FCC.

Abandon ship, man overboard drills, training shall be logged or otherwise documented for review by the CG upon request. The drill entry shall include the ff info: 1) Date of the drill and training; and (2) General description of the drill scenario and training topics. No records of required emergency drills were recorded and available during inspection.

The EPIRB test required shall be logged or otherwise documented, as applicable. No records of required EPIRB testing were available during inspection.

Each package shall be enclosed in a jacket of tough, transparent material, properly sealed, which shall meet the watertight requirements. Carton & contents shall conform to the requirements of Federal Specification. Replace broken & incomplete First Aid kit onboard.

The operator must secure each Type III device in a manner which prevents discharge of sewage through an acceptable methods of securing the device. The macerator pump does not comply with Type II MSD requirements and MSD is therefore considered Type III. Although the current installation of the pump preclude the vessel from discharging the effluent on the side without turning the pump "on", Environmental Protection Agency requires that all valve leading to an overboard discharge was secured. During the inspection, the discharge valve was left in the "open" position. Note that in order to access the valve, one must open the hatch located at the operator station first. Below are acceptable methods of securing the device: (1) Closing each valve leading to an overboard discharge and removing the handle; (2) Padlocking each valve leading to an overboard discharge in the closed position; or (3) Using a non-releasable wire-tie to hold each valve leading to an overboard discharge in the closed position.

Bilge pump in engine compartment not secured permanently. Secure pump.

Gasket on lazarette deck hatch came off. Repair/replace gasket.

FCC Marine Operator permit not onboard. Provide copy.

Replace expired asprin, eye wash, and moist burn pads in first aid kit 46CFR 184.710

Improper line material on life float floating water light. Replace with appropriate line. 46 CFR 180.175f.4

Floating water light for the ring buoy did not energize. Replace floating light. Vessel is restricted to daytime operations.

Clean paint and sealant from outboard port swim platform hull connection point. 46 CFR 176.610 17c

Replace life float to the satisfaction of the attending marine inspector.

Life float paddles are unservicable and need replacement. Water light batteries expired. Vessel is restriceted to daytime operations.

VHF does not have GPS or MMSI information. This information needs to be added to VHF installation.

Install chain on port quarter to bring height of handrail to 36".

Label fuel oil shut off valves.

Procure and install a new oil pollution placard.

[withheld — contains personal information; the deficiency system, dates, and resolution status are shown above]

Provide evidence of drug and alcohol training.

MAB01: Provide documentation on specifications of fuel hoses/ Due 15JUN2017 Their fuel supply line had SAE J1527 written on them; other fuel lines aft (from fuel filter into engine) had nothing written on them, Operator said they have been that way since he's owned it.

Repair life rafts IAW manufacturer's instructions. Due 15JUN2017

Provide corrosion resistant clip on life ring water light and lifeline. Due 15JUN2017

JE01 Renew properly endorsed COD

JE02 Provide drill / crew training log

JE03 Provide sufficient hand flares for route

JE04 Provide proper first aid kit (asprin).

JE05 Renew condition of life floats to like new condition and replace water light battery.

JE06 Provide approved bracket for portable fire extingusher in cabin.

JE07 Repair high level bilge alarm in forward most compartment.

JE08 Prevent excessive leak at rudder packing.

Install rail courses on stern as discussed.

Repair audible alarm for Sea-Fire pre-engineered fire extinguishing system.

Seal penetrations in engine room bulkhead.

Remove oil and debris from bilges.

Label bilge pump indicators at operating station.

Remove dead end wiring from engine compartment.

Update emergency instructions in accordance with practiced procedures.

Repair two deck beams in fuel compartment as shown/marked to vessel rep. Due prior to credit drydock.

Submit repair proposal to repair missing/wasted plywood decking above fuel tank. Prior to credit drydock.

Provide updated charts for operating area.

Remove plastic wire ties and replace with metal where attached to bulkhead in engine room.

Make wire penetration on the midship transverse bulkhead between engine space and fuel compartment watertight.

Make repairs to life float with approved manufacturers repair kit.

Provide proof of EAP training and company policy statement.

Replace expired alcohol swabs.

Provide safety radiotelephony certificate.

Crop and renew wasted wood in overhead above fuel shut off valve.

Mount B-II fire extinguisher in forward compartment.

Replace existing steering gear hose with one meeting 46 CFR 182.720 (SAE J1942 hose and J1475 fittings).

Prove proper operation of MDE RPM Gauge.

Provide current navigation pubs (NTM, Coast Pilot [name withheld], Tide/Currents)

Provide current charts for area of operation.

Provide lifesaving equipment log to include monthly EPIRB test.

Provide proof of current training with deckhand.

Provide plug for drain hole in forepeak.

Double clamp all vital system hoses.

Provide plug for Racor filter impingment bowl.

Make bulkhead, stbd side aft watertight.

Repair / replace cracked starboard side running light.

Provide protective covering for batteries.

Provide vent closures for engine room.

Provide deck rail on transum IAW 46 CFR 177.900. Make rail hight 39 1/2".

Provide A-II portable fire extinguisher for main deck.

Correct discrepancies found during DAPI audit.

Provide servicing report for fixed fire extinguishing system in engine room.

Provide proper size paddles for life float.

Lable all lifejackets with vessel name.

Provide NOAA registration for EPRB.

Repair / replace RPM guage for main engine.

Conduct fire and man overboard drills.

Provide record of training and drills.

Fixed fire extinguishing system in engine room is discharged, replace in kind.

Provide one type I child size lifejacket.

Provise license for operator of vessel. Master has not received license from REC Miami.

Provide current radio safety certificate.

Complete satisfacory drug audit.

Provide annual report for fixed fire extinguishing system,

Show proper operation of life float waterlight.

Properly attach life float painter.

Prove proper operation of all high water alarms and mount switches and floats.

Remove dead ended wiring throughout vessel.

Prove proper operation of fuel compartment scuttle.

Remove plastic pet cocks on raycor fuel filters.

Prove proper operation of stern light.

Provide sound producing device onboard (operational horn).

Properly seal hole at base of collision bulkhead.

Properly mount throttle and red gear cable.

Provide proper B-II extinguisher for accommodation space.

Plug through hull fitting starboard engine room hull.

Provide 25 adult and 03 children lifejackets.

Provide protective covering for batteries.

Provide minimum of 03 fire buckets.

Properly seal all holes in aft engine room bulkhead.

Remove all oil in bilges and keep oil free, or disconnect automatic float switch in aft engine room bilge pump.

Provide naviagtional publications.

Provide a servicable, lighted magnetic compass onboard.

Properly provide fused protection to service batteries charging circuit.

Provide 06 red hand flares and 06 orange smoke.

Show proper operation of vent closure system for engine room fixed system.

Provide safety lines on stern of vessel.

Prove proper operation of all indicator lights on automatic bilge pumps.

Prove proper operation of all enine guages at operating station.

Remove and present for inspection the swim step and repair all broken welds.

Renew hull transducer block.

Present all sea valves and sea chest for inspection.

Renew all PVC plastic through hull fittings with approved material.

Seal 4 inch hole in forward bulkhead portside engine room.

Remove vessel start batteries, clean box and present for inspection.

Remove old wasted bilge piping and seal all bulkhead penetrations.

Crop out all rotted core material in collision bulkhead and renew.

Provide working waterlight for Ring Buoy

Provide additional fire extinguisher as required on vessels COI

Replace deteriorated hose on CO2 extinguisher located starboard main deck.

Replace deteriorated hose clamps on exhaust system flex hose located in engine room. LEGACY COMPONENT DESC: Piping (exhaust)

Provide current proof of compliance for personnel in drug testing program including pre-employment testing. LEGACY COMPONENT DESC: Drug Test Records

Provide proof of MIS submittal LEGACY COMPONENT DESC: MIS Form

Provide familiarization training for crew members and demonstrate proficiency in emergency equipment and procedures. LEGACY COMPONENT DESC: Familiarization Training

Demonstrate proper operation of installed fixed fire fighting system engine shutdown controls. LEGACY COMPONENT DESC: Operating Controls

Provide complete first aid kit LEGACY COMPONENT DESC: Medicine Chest

Provide means for gauging F/O tank LEGACY COMPONENT DESC: Tank

Provide two working flashlights LEGACY COMPONENT DESC: Battery Operated flashlights

Replace overboard discharge valve for the main deck drain on the starboard side. LEGACY COMPONENT DESC: Overboard valve

Properly repair or replace MSD system and hoses LEGACY COMPONENT DESC: Marine Sanitation Device, Type III

Replace deteriorated flares LEGACY COMPONENT DESC: Condition

Grind out damaged areas of hull and present for inspection. LEGACY COMPONENT DESC: Bottom Plating

Make repair proposal for damaged areas of hull. LEGACY COMPONENT DESC: Bottom Plating

Renew port side aft seating frame (wasted).

Renew broken engine mount port side forward and renew mounting plate.

Grind out damage to deck in forward v-berth space and propose repair. LEGACY COMPONENT DESC: Deck Plating

Provide double hose clamps on bilge pump and head intake hoses in forward bilge. LEGACY COMPONENT DESC: Hose

Clean battery terminals of corrision LEGACY COMPONENT DESC: Battery Conductor

Repair/renew shifting cable and bracket.

Restow holding tank and install bracket clamp. LEGACY COMPONENT DESC: Marine Sanitation Device, Type III

Repair/ replace propeller. LEGACY COMPONENT DESC: Propeller (fixed pitch)

Repairs spray rails, port and starboard side. LEGACY COMPONENT DESC: Sheerstrake

Repair seam between deck and hull. LEGACY COMPONENT DESC: Hull Plating

FWD compartment hatch access to the wheather deck is not watertight LEGACY COMPONENT DESC: FWD hatch

Engine room hatch on the main deck exposed to the wheather is not watertight LEGACY COMPONENT DESC: Engine room hatch

Ladder rungs are deteriorated and missing from the fwd cabin access. LEGACY COMPONENT DESC: Ladder

Provide window for main deck accomadation space LEGACY COMPONENT DESC: Window

Provide securing fixture for closing of portlight in starboard head LEGACY COMPONENT DESC: Portlight securing fixture

Repair emergency F/O shut-off valve cover LEGACY COMPONENT DESC: Access cover

Provide all required documentaion for current drug testing program LEGACY COMPONENT DESC: Recordkeeping

Provide new life ring buoy & provide new life line LEGACY COMPONENT DESC: Condition

Provide required portable hand bilge pump LEGACY COMPONENT DESC: Pump

Replace hydraulic hoses & fittings on supply/return from the reduction gear LEGACY COMPONENT DESC: Hoses & Fittings

Lash two paddles to lifefloat LEGACY COMPONENT DESC: Paddles

Demonstrate proper operation of fixed fire extinguishing system engine shutdown LEGACY COMPONENT DESC: Operating Controls

Replace or repair bilge manifold pipe and valves LEGACY COMPONENT DESC: Manifold

Install valve on outlet side of raycor fuel filter. LEGACY COMPONENT DESC: Valve

Remove horn in front of port navigation light. LEGACY COMPONENT DESC: Navigation Lights

Provide current navigation publications. LEGACY COMPONENT DESC: Navigation Publications

Tighten rudder packing gland to prevent excess leakage. LEGACY COMPONENT DESC: Rudder

Provide emergency broadcast placard. LEGACY COMPONENT DESC: Emergency Instructions

Provide three new adult type I PFDs. LEGACY COMPONENT DESC: Condition

Provide sixty feet of life line for ring life buoy. LEGACY COMPONENT DESC: Buoyant Lifeline

Provide means of properly securing port light in port side cabin. LEGACY COMPONENT DESC: Port Light

Prior to the carriage of passengers, re-work boath watertight hatches on main deck to make the operable.

Prior to the carriage of passengers, tighten shaft rudder packing gland.

Prior to the carriage of passengers, provide charts and publications IAW 46CFR185.20-35.

Prior to the carriage of passengers, provide a copy of the companies 2001 Drug Testing Program with Employee Information Service.

Prior to the carrigae of passengers, replace Life Float IAW 46CFR180.130.

Prior to the carriage of passengers at night, provid a compass light.

Prior to 20 MAr 00, replace all lines associated with life float.

Prior to 20 Mar 00, rewrite emergency instructions for Fire At Sea.

Prior to 20 Mar 00, provide two hose clamps on all through hull fittings and associated hoses.

Prior to 20 Mar 00, clean navigational lens on running lights. (PORT & STBD)

Prior to the carriage of passengers, replace all bad retro-reflective tape on all life preservers.

Rewrite emergency check list to be vessel specific.

Provide positive latch for main engine compt hatch.

Renew support bolts for rudder assembly.

REPLACE WEAK LINK WITH AN APPROVED, CORRECT SIZE LINK BEFORE OPERATING WITHPASSENGERS.

SERVICE ALL FIRE EXTINGUISHERS.

Renew angle brackets on end of rudder support bracket.

Provide evidence of fire extinguisher servicing.

Attach 60' painter to ring buoy(current painter is not 60').

Post emergency check off procedures.

Label emergency fuel oil shut off valve.

PROVIDE WRITTEN PROOF OF A CHEMICAL TESTING PROGRAM IN ACCORDANCE WITH 46 CFR PART 16.

MISSING LABEL EMERG FUEL SHUT-OFF.

LINES ON LIFERING ROTTED

REPLACE FLEXIBLE FUEL LINES, BOTH SUPPLY AND RETURN, WITH COPPER, NICKEL COPPER OR COPPER NICKEL PIPING HAVING A MINIMUM WALL THICKNESS OF 0.035 IN.

SCRAPE AND TREAT FUZZY WOOD IN ENGINE COMPARTMENT.

RECONNECT UNDER DECK BEAMS IN LAZARETTE (AFTER 3 TO STARBOARD, AFTER BEAM MIDSHIP, AFTER BEAM TO PORT)